§ 26-72-030. Permitted residential density and development criteria.

The use of land and structures within this district is subject to this article and the applicable regulations of this chapter. Policies and criteria of the general plan and any applicable specific or area plan or local area development guidelines shall supersede the standards herein.

(a)

Density. Residential density shall be as shown in the general plan land use element, or that density permitted by a B combining district, whichever is more restrictive. There shall be no minimum lot size for inclusion into the MR district.

(b)

Minimum Yard Requirements for Uses Other than Mineral Extraction and Production:

(1)

Front Yard Required. Ten percent (10%) of the depth of the lot, but not more than one hundred feet (100′) nor less than thirty feet (30′).

(2)

Side Yard Required. Ten percent (10%) of the width of the lot, but not more than fifty feet (50′).

(3)

Rear Yard Required. Fifty feet (50′).

(c)

Maximum Building Height.

(1)

Fifty feet (50′), provided that additional height may be permitted where special structures are required if a use permit or use permit waiver is first secured in each case.

(2)

Maximum height for telecommunication facilities is subject to the provisions of this article and Section 26-88-130.

(d)

Parking Requirements.

(1)

On-site parking shall be screened where practical from view from public roadways by natural vegetation, landscaping, natural topography, fencing or structures.

(2)

On-site parking shall not block emergency vehicle accessways and turnarounds.

(Ord. No. 4973 § 13(d),1996; Ord. No. 4643, 1993; Ord. No. 2862.)